Production flow
Confirm the input is Dry Amethelis
Fresh Amethelis belongs in the Steam dryer, not the Florin room. Route the dried output into a separate buffer and keep untreated petals on a return or overflow path. Mixed input makes a failed ignition difficult to diagnose because the two materials can look similar in a pile.
Collect enough Dry Amethelis for a small test batch, then stop the dryer output. This gives you a known amount to burn and prevents the gas chamber from filling with petals while you inspect the cold side.
- Scan a sample if the material state is unclear.
- Keep fresh and Dry Amethelis in different bins.
- Add a gate between the buffer and gas chamber.
Build and inspect the sealed gas path
Build a roof and side walls around the ignition area, then create one deliberate path toward the cold chamber. Florin rises and spreads through available gaps, so the route should guide that movement instead of relying on a wide open room.
Inspect corners, Conveyor Portal openings, and the join between the hot and cold zones before releasing gas. Leave player access outside the sealed volume so repairs do not require opening the roof during a batch.
- Seal the roof above the ignition point.
- Keep Steam outside the Florin path.
- Place the cold zone before the final gas exit.
- Reserve a separate floor basin for Florinol.
Release Florin with a small heat test
Feed one batch of Dry Amethelis into the hot side and apply controlled heat. Watch the material ignite and follow the Florin gas toward the cold zone. Stop adding petals until the first gas has either condensed or revealed a leak.
If no gas appears, verify the input state and heat contact. If gas appears but leaves the intended route, stop the input, seal that opening, and repeat with a smaller batch. More input will not repair a missing wall.
Condense Florin into Florinol
Both faces must have the right contact at the same time: Snow or a cold Thermal Buffer on top, Florin gas below. A cold source somewhere in the room does not establish that contact. Keep the upper cold supply available as the lower gas reaches the machine.
The conversion produces Florinol and Gold. Give the liquid an open collection or Pump route, and keep Gold from burying the gas approach. First observe one small batch convert and leave before opening the continuous feed.
Top contact: Snow or cold Thermal Buffer
Condenser
Bottom contact: Florin gas
Result: Florinol + Gold
If Florin turns back into Dry Amethelis
The official material reference says Florin that escapes into the sky can return as Dry Amethelis. Inspect the gas route and its height before adding more cold. Guide the gas to the Condenser before it leaves the intended chamber.
Players have solved this symptom by moving the process lower, but their exact tile counts are not a universal placement rule. If the machine receives gas and still produces no Florinol, check top cold contact and output space next.
Restart the chain after a failed batch
Close the Dry Amethelis input, clear solids from the ignition floor, and inspect the gas roof. Restore the cold supply and empty the Florinol basin before the next attempt.
Restart in the same order every time: cold side ready, collection route open, gas chamber sealed, then heat and input. That order makes the first visible failure point useful instead of letting several stages fail together.
Common questions
What is Florin made from?
Burn Dry Amethelis to release Florin gas.
How do I make Florinol?
Give a Condenser Florin at its bottom face and Snow or a cold Thermal Buffer at its top simultaneously.
Why does Florin turn back into Dry Amethelis?
Check whether it escapes into the sky before reaching the Condenser. The official material reference documents this return conversion.