Sandustry flower guide

Prepare a Wet Seed buffer and sealed plant room

Prove the Seed washer before connecting the Planter Box. The input bin should contain Wet Seed only, with a gate or break in the route that lets you stop delivery while the plant room is open.

Build the first plant room around one or a few Planter Boxes. Leave empty space above and beside them for growth, plus separate exits below for Gold and Amethelis. Large empty chambers look safe but allow escaped plant pixels to reach more filters before you notice the problem.

• Keep dry Seed out of the planter input.
• Add a manual stop before the first Planter Box.
• Leave an inspection opening away from the heat source.
• Build both product exits before planting.

Grow one batch before enabling heat

Release a small amount of Wet Seed and watch where it lands. Confirm the Planter Box accepts the material and the Flower grows inside the planned boundary. Stop delivery as soon as the first batch begins to spread.

If nothing grows, check the material state before rebuilding the room. Dry Seed at the planter means the problem belongs in the washer or transport route. Wet Seed piling beside the Planter Box points to placement or blocked contact.

Burn Flowers with controlled heat

Use a Pyro Dispenser, Lava-backed thermal setup, or another controlled heat source that reaches mature Flowers without filling the room with unrelated hot material. The goal is to burn growth soon enough that the next Seed does not extend the plant into the output lanes.

Enable heat for one batch and watch the room until Gold and Amethelis appear. If Flowers survive in a corner, improve heat coverage or airflow before adding more Planter Boxes. Continuous Seed input will amplify every cold spot.

• Keep the heat supply outside the product fall path.
• Do not let Cinder or Snow enter the plant chamber.
• Confirm every growth area reaches the burn zone.

Separate Gold from Amethelis

Give Gold a clear downward route into storage and guide Amethelis toward a separate petal buffer or Steam dryer. Filters, Fans, Clearing Frames, and Conveyor Portals can help, but the room still needs open volume around each exit.

Run several cycles and inspect the material resting against the Planter Box. Gold in the petal route means the filter boundary needs adjustment. Amethelis above the Gold exit means the lighter material lacks a reliable path toward its own stage.

Clear a plant jam in the correct order

Stop Wet Seed first, then disable or isolate the heat source if you need to enter the room. Remove stray Seed and live growth, empty the Gold route, and clear Amethelis from the dryer entrance. Reopen the product exits before restoring Seed delivery.

Restart with one batch and watch the place where the previous jam began. If the same corner fills again, change that local path instead of making the entire chamber larger.